Communication via Profinet - Druckversion +- LabVIEWForum.de (https://www.labviewforum.de) +-- Forum: LabVIEW (/Forum-LabVIEW) +--- Forum: LabVIEW Allgemein (/Forum-LabVIEW-Allgemein) +---- Forum: Datenkommunikation (/Forum-Datenkommunikation) +---- Thema: Communication via Profinet (/Thread-Communication-via-Profinet) |
Communication via Profinet - Sun87 - 06.09.2013 12:23 Hi all, I am new to this forum and sorry I can't speak German. I have a question regarding to use Labview with Profinet. Since I searched a lot of information about Hilscher and Interbus, so I guess maybe some of you are also familiar with profinet and give me some help. I have a device which previously worked with Interbus standard. Now the system is upgraded and the device has to be working with profinet standard. I am not quite familiar with profinet, but according to my knowledge, profinet has the same physical layer as normal ethernet and also uses TCP/IP protocol. Does that mean I can connect my Labview program with this device via normal TCP/IP connections? Is there any special toolbox that can be used for profinet? Thank you so much for your help! Best regards, Sun87 RE: Communication via Profinet - Y-P - 12.09.2013 09:20 Have you found something yet? Maybe this module is something for you: NI CompactRIO PROFINET Slave C Series Module Greetings Markus |